Difference between revisions of "Mendel90 3D Printer"

From ENTS
Jump to: navigation, search
(Current State)
(6 intermediate revisions by one user not shown)
Line 7: Line 7:
 
== Current State ==
 
== Current State ==
 
Currently working with small issues.  Interface is at http://members.ents.ca:5000
 
Currently working with small issues.  Interface is at http://members.ents.ca:5000
 +
 +
== Who Can Certify You? ==
 +
[[User:Hov]]
 +
[[User:grelli]]
 +
[[User:khawkings]]
  
 
== Specifications ==
 
== Specifications ==
* '''Spec Name1''' Spec Value1
+
 
  
 
== Equipment Settings ==
 
== Equipment Settings ==
 
== Modifications ==
 
== Modifications ==
 +
The firmware has been modified to make extruder 1 (of extruders 0 and 1) behave like extruder 0.  There was a magic smoke event that cooked the current limiting resistor for the extruder 0 heater.
 +
 
== Working on it ==
 
== Working on it ==
 
== Known Problems ==
 
== Known Problems ==
 +
If the hot end stops making itself hot then unplug and plug back in the connectors for the hot end on the x-carriage (the 4 pin connectors to the protoboards)
 +
 
== Future Ideas ==
 
== Future Ideas ==
 +
 +
== Firmware ==

Revision as of 17:29, 2 August 2013

Back to list of Equipment

Mendel90.jpg

Contents

Label

Mendel90 3D Printer http://ents.ca/index.php/Mendel90_3D_Printer

General

  • Owner/Loaner: ENTS
  • Make/Model: Mendel90
  • Usability: WORKING
  • Contact: User:Hov
  • Where: Main Workroom
  • Certification Needed: YES
  • Hackable: NO
  • Estimated Value: $600

Instructions

{{{Instructions}}}


Mendel 90

3D printing is a thing and it's a thing we can do!

Current State

Currently working with small issues. Interface is at http://members.ents.ca:5000

Who Can Certify You?

User:Hov User:grelli User:khawkings

Specifications

Equipment Settings

Modifications

The firmware has been modified to make extruder 1 (of extruders 0 and 1) behave like extruder 0. There was a magic smoke event that cooked the current limiting resistor for the extruder 0 heater.

Working on it

Known Problems

If the hot end stops making itself hot then unplug and plug back in the connectors for the hot end on the x-carriage (the 4 pin connectors to the protoboards)

Future Ideas

Firmware

Personal tools
Namespaces

Variants
Actions
Navigation
Members
Toolbox